Marion County Metal Roofs
We handle metal roof coating for commercial buildings in Lebanon and across Marion County. After hail, we check every dent, rib, and gutter before any new coat goes on.
Hail dents the steel and can crack the coating at the point of impact, especially on older, harder films. A small dent with intact coating is cosmetic. A cracked film over a dent lets water reach the steel, and rust follows within a season.
Lebanon owners with metal shops, storage buildings, and storefronts call us after a storm to sort cosmetic dents from damage that needs work. We photograph and date what we find before any repair.
What We Check After HailWind and hail leave different marks on a metal roof. These rows show what each storm leaves behind and how the coating job handles it.
Hailstones flex the panel and the older coating cracks at the dent center instead of stretching.
Clean the cracked spots, prime where steel shows, and recoat each dent zone.
Large hail crushes rib tops, which opens the side laps that rely on the rib shape.
Reseal the affected side laps with fabric, and swap panels where ribs are crushed flat.
Hail and ice load the trough, and the hangers pull loose from the fascia.
Rehang the gutter, reseal its seams and end caps, and refasten the eave trim.
Strong gusts pry at caps whose screws have backed out over the years.
Refasten the cap, replace failed closures, and coat the joint where cap meets panel.
These gains apply once storm damage is repaired and the roof is primed and coated as one surface.
Recoating dent zones after a storm puts a fresh, flexible film over the spots where the old coating split. That keeps water off the steel at each dent, so a hailstorm stays a cosmetic event instead of a rust problem a year later.
Photos of dents, ribs, and gutters taken before any repair give you the dated record insurers ask for after a storm.
Fresh coating flexes with the panel better than an old, hardened film, so the next hail dent is less likely to crack it.
Lightly dented steel stays on the building under a new coat, so only crushed or holed sheets get replaced.
After a storm, the right system depends on how much of the roof took hits and how the roof drains.
Roofs with scattered cracks get each damaged area cleaned, primed, and recoated with the coating family already on the roof.
Low-slope Lebanon roofs with hail damage and water sitting at end laps take a full silicone coat over the repaired panels.
Heavily dented metal can take foam that fills the dents and ribs, then a top coat, when the steel underneath stays solid.
Call before anyone patches anything. Dated photos of dents, ribs, and gutters come first, and we take them on the first visit.
Storm work starts with documentation and ends with a recoated roof. This is the order on a Lebanon metal building.
We walk every slope after the storm, marking cracked coating at dent centers, bent ribs, and lifted caps, then look inside for new drips under the damaged areas.
Each damaged spot is photographed with dates and roof location, so you have a record to hand an insurer before any repair changes the evidence.
Crushed panels are swapped, gutters are rehung and resealed, and ridge caps get new closures and screws.
Where cracks reached bare steel, the area is cleaned and primed with the primer the coating maker lists for that surface.
Dent zones, or the whole roof when damage is widespread, get coating in the same family already on the roof.
Our metal roof coating work covers Lebanon, Bardstown, Springfield, and Taylorsville. For a building outside those four towns, call us or send us a message and we will say whether the job fits.
The short answer sits on each row. Open a row for more.
Hail dents the steel and can crack or chip the coating at the point of impact, most often on older, harder films. Small dents with intact coating are cosmetic. Cracked coating over a dent lets water reach the steel. Check for fractures at dent centers, bent ribs, cracked skylight panels, and loose gutters, and photograph everything with dates.
The state listing for Marion County names a city inspector as the local office, so Lebanon roof work starts there. Buildings outside city limits need a call to the Kentucky Department of Housing, Buildings and Construction. Panel replacement and foam change the roof more than coating does, so describe the work plainly and bring photos and the roof area.
Marion County is served in part by Inter-County Energy, Salt River Electric, and Taylor County RECC, according to East Kentucky Power Cooperative. Taylor County RECC is based in Campbellsville, so some owners deal with a different office than neighbors. Check the name on the bill, then ask whether a reflective coating or foam insulation counts toward any current program.
Scattered cracks call for spot repairs in the same coating family. When cracks cover most slopes, or the old film was already thin, a full recoat costs less per square foot than chasing dozens of spots. The storm walk shows which case your roof is in.
Check within a few days, before the next rain finds cracked spots. Walk the roof only when it is dry and safe, or have it inspected from a lift. Take dated photos first, and wait to patch anything until the damage is recorded.
Send the roof size and what you saw after the storm for a free ballpark figure.
Leave a name and number and we will call you back about your metal roof.
Or call now: (502) 289-9569